When Not In Use - Roland CAMM JET CJ-70 User Manual

14 When Not in Use...

When not in use, leave the pinch rollers in the raised state. The pinch rollers may be deformed if allowed to
remain in the lowered state.
After detaching the blade holder from the tool carriage, do not tighten the tool setscrew. Leave this screw loose.
Tightening the screw makes the hole for inserting the holder to progressively smaller, which on turn makes it
difficult to install the blade holder.
1
If the SETUP LED is lighted, press the
key.
The carriage moves to the right.
The SETUP LED goes out
3
Loosen the tool securing screw on the
tool carriage, then remove the blade
holder from the tool carriage.
Blade holder
Loosen
Tool securing
screw
5
Press the key to switch off the power.
The printing carriage moves to the standby position and the head is capped.
If the printing carriage is already at the standby position, no movement takes place.
There is no need to turn off the main power switch.
POWER LED goes out
22
2
Lower the sheet loading levers and remove the material.
4
Press the push-pin and remove the blade from the blade
holder.
Cutting
carriage
Push-pin
Blade holder
If a blade was used, wipe
Blade the blade with a soft cloth
to remove any material
that may cling to it.
Printing carriage
Standby position