Roland CAMM JET CJ-70 User Manual page 20

3
Raise the sheet loading levers to secure the
material in place.
4
If using roll material, move the provisionally tightened
stopper to match the width of the material, then
securely tighten the stopper retaining screw.
5
Use the and
choose the material configuration.
SELECT SHEET
ROLL EDGE PIECE
6
Press the key.
The sheet size is detected, and the CJ-70/60 is readied for plotting or cutting.
* If "PREFEED" is set to "ENABLE," pressing the
for the length that has been set.
Changing the "PREFEED" setting to "ENABLE" is recommended when using rolled
material.
For more information, see "22 Description of Keys and Display Menus".
When using sheet material
• If the material curls toward the material face (cut face), it will cause the material to slip when loaded onto the CJ-
70/60, and may adversely affect printing/cutting. In this case pre-bend the material downward so that the material
edge is not caught the front cover and guard bar during operation.
• If the material strikes the shaft that is installed on the stand, then remove the shaft.
18
ROLL:
keys to
EDGE:
PIECE: If sheet material has been loaded, the width and
key causes the sheet to be fed
* If and only if the prefeed function is enabled (i.e., set to
"ENABLE"), then after securing the material in place,
pull out some material from the roll.
Pull out material from the roll
Media flange
Stopper retaining screw
If roll material has been loaded, only the width of
the material is detected.
If roll material has been loaded, the width of the
material and the position of the front edge are
detected.
length of the material are detected.
Sheet loading lever
Roll material
The SETUP LED lights up