Table of Contents
Advertisement
Level 1 and 2 Service Manual
Removing and Replacing the Camera Assembly
G
6809505A63-O
1.
Remove the battery cover, battery, USIM, antenna, rear housing, and transceiver board
assembly, flip assembly cover, and CLI lens cover as described in the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2.
Unlock the ZIF connector and remove the camera assembly flex connector.
3.
Carefully lift the camera assembly and flex out of the flip assembly
(see Figure 13).
Camera Assembly
Figure 13. Camera Assembly Removal
4.
To replace, carefully press the camera assembly into its slot in the flip assembly.
5.
Insert the end of the camera assembly flex cable into its slot in the ZIF connector on the
flip display assembly. Avoid damage to the flex cable.
6.
Replace the flip assembly cover, transceiver board, rear housing, antenna, USIM, battery,
and battery cover as described in the procedures.
September 26, 2006
Camera Flex
ZIF Connector
Disassembly
25
Advertisement
Table of Contents
