Terminals And Connectors - Christie LX1000 User Manual

Terminals and Connectors

SERIAL PORT IN TERMINAL
If you control the projector by computer, you must
connect a cable (not supplied) from your computer
to this terminal.
SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT IN.
More than two projectors can be controlled with
one computer by connecting SERIAL PORT IN of
another projector to this terminal.
USB CONNECTOR (Series B)
USB connector is to used to service the projector.
R/C JACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
RESET button
LX1000 User Manual
020-000141-01 Rev. 1 (05-2009)
Part Names and Functions
DVI INPUT TERMINAL
Connect computer output (Digital/DVI-D type) to
this terminal. (p.20)
HD (HDCP Compatible) signal can be also
connected. (p.21)
D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog D-sub 15-pin
type) to this terminal. (pp.20-21)
5 BNC INPUT JACKS
Connect the component or composite video
output signal from video equipment to VIDEO/Y,
Pb/Cb, and Pr/Cr jacks or connect the computer
output signal (5 BNC Type [Green, Blue, Red,
Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V
jacks. (pp.20–21)
S-VIDEO INPUT JACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).
11