This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on
pages 12 to 14 and connect properly.
AUDIO INPUT 1 JACK
Connect an audio output
(stereo) from computer to
this jack.
RESET BUTTON
This projector uses a micro processor
to control this unit, and occasionally,
this micro processor may malfunction
and need to be reset. This can be
done by pressing RESET button with a
pen, which will shut down and restart
unit. Do not use RESET function
excessively.
5 BNC INPUT JACKS
Connect component video
output (Y, Cb, Cr or Y, Pb, Pr)
from video equipment to
VIDEO/Y, Cb/Pb and Cr/Pr
jacks or connect computer
output {5 BNC Type (Green,
Blue, Red, Horiz. Sync and
Vert. Sync.)} from computer
to G, B, R, H/V and V jacks.
TERMINALS OF PROJECTOR
INPUT TERMINAL (ANALOG)
Connect computer output
(Analog HDB 15 pin type)
to this terminal.
ANALOG
AUDIO 1
G
VIDEO/Y
VIDEO/Y Cb/Pb
VIDEO INPUT JACKS
Connect composite video
output from video equipment
to VIDEO/Y jack or connect
component video outputs to
VIDEO/Y, Cb/Pb and Cr/Pr
jacks.
- 7 -
INPUT TERMINAL (DIGITAL)
Connect computer output
(Digital DVI-D type) to this
terminal.
HD (HDCP Compatible) signal
can also be connected.
INPUT 1
DIGITAL(DVI-D)
R/C JACK
CONTROL PORT
RESET
AUDIO 2
B
R
H/V
V
Cb/Pb
Cr/Pr
INPUT 2
S–VIDEO
Cr/Pr
R–AUDIO–L
( MONO )
INPUT 3
AUDIO INPUT JACKS
Connect an audio output
from video equipment to
these jacks.
When the audio output is
monaural, connect it to
L (MONO) jack.
AUDIO INPUT 2 JACK
Connect an audio output
(stereo) from computer to
this jack.
R/C JACK
When using Wired/Wireless
Remote Control Unit as Wired
Remote Control, Connect
Wired Remote Control Unit to
this jack with Remote Control
Cable (not supplied).
CONTROL PORT CONNECTOR
When controlling the projector
from a computer, connect the
computer to this connector
with a control cable.
S-VIDEO INPUT JACK
Connect S-VIDEO
output from video
equipment to this
jack.