Table of Contents
Advertisement
Weighing the sample mass
In the single balance mode we recommend to weigh the sample mass
twice a day.
Remove plug from sensor unit.
Note
Only one sensor unit may be disconnected. Please do not pull the magneto cable but use
the serrated area of the plug instead.
The number of samples is limited to 20.
Follow the instructions on the screen.
Disconnect sensor unit from the balance
and connect it again to the T-piece of
the tensioLINK
. This function is supported
®
with a menu.
Note
If you run more sensor units with one balance the magneto cable is not needed.
The system identifies automatically the sen-
sor unit having been put on the balance.
A menu opens on the screen showing
information about the status and the
weighing routine.
Actual sample mass
The menu leads you through the
weighing procedure.
60 | Measuring
Advertisement
Table of Contents
