Table of Contents
Advertisement
Note
Be extremely cautious when you screw in the tensio shafts filled
with water. The pressure that can damage the pressure
sensor increases abruptly at about 9 turns. This pressure
should not exceed 2000 hPa (200 kPa) – and in no case
3000 hPa (300 kPa).
Repeat all steps for the second tensio
shaft.
When all steps are done click on "Close"
and you get to the page where you
opened the refilling wizard.
Note
If you open the wizard during a measurement the measuring process is interrupted.
Therefore the wizard is closed automatically after 2 min and the measurement is continued.
45 | Preparing the measurement
Advertisement
Table of Contents
