Measuring; Multi Balance Mode (One Balance Per Sensor Unit) - UMS HYPROP Operation Manual

Measuring

Multi balance mode
(one balance per sensor unit)
Click on the "Show devices" icon.
If the balance does not show on the
screen check if balance is turned on.
Click on the "Measurement wizard" icon.
Enter the following data – either via the
wizard or directly in the manager:
- measuring mode,
- measuring unit,
- name of the soil sample,
- sample ring type and
- balance type.
Push start button.
Note
The magneto cable from the balance to the magnet clamp must lie freely as a loop
without touching anything.
Before you start weighing wait for at least 5 minutes to let the cable tension release.
After entering the
key legend changes to "Start".
Actual and maximum
tension value of the
upper and lower
tensio shaft in minute
cycle)
58 | Measuring
data the
!
Actual
sample mass
(in minute cycle)