FIBARO FGK-10x Operating Manual page 16

16
i
NOTE
Parameter 51 is active
only if parameter 50 is
not set to 0.
i
NOTE
Temperature meas-
urement is performed
before sending any
report (regardless of
parameter no. 50). Ex-
cessive reporting can
affect battery lifetime.
Reporting on the ba-
sis of temperature
change (parameter
no. 51) is recommend-
ed.
ADVAnCED PARAMETERS
50. Interval of temperature measurements
This parameter defines how often the temperature will be measured.
The shorter the time, the more frequently the temperature will be
measured, but the battery life will shorten.
Available settings: 0 - temperature measurements disabled
Default setting:
51. Temperature reports threshold
This parameter defines the change of temperature in comparison with last
reported, resulting in temperature report being sent to the main controller.
Available settings: 0 - temperature reports based on threshold disabled
Default setting:
52. Interval of temperature reports
This parameter determines how often the temperature reports will be
sent to the main controller.
Available settings: 0 - periodic temperature reports disabled
Default setting:
53. Temperature offset
The value to be added to the actual temperature, measured by the sen-
sor (temperature compensation).
Available settings: -1000-1000 (-100-100°C, 0.1°C step)
Default setting:
54. Temperature alarm reports
Temperature alarms reported to the Z-Wave controller. Thresholds are
set in parameters 55 and 56.
Available settings: 0 - temperature alarms disabled
Default setting:
55. High temperature alarm threshold
If temperature is higher than set value, overheat notification will be
sent and high temperature scene will be triggered (if activated).
Available settings: 0-1000 (0-100°C, 0.1°C step)
Default setting:
5-32400 - time in seconds
300 (5min) Parameter size:
1-300 - temperature threshold (0.1-30°C, 0.1°C step)
10 (1°C )
Parameter size:
5-32400 - time in seconds
0
Parameter size:
0 (0°C )
Parameter size:
1 - high temperature alarm
2 - low temperature alarm
3 - high and low temperature alarms enabled
0
Parameter size:
540 (54°) Parameter size:
2 [bytes]
2 [bytes]
2 [bytes]
4 [bytes]
1 [byte]
2 [bytes]