13.3 ELECTRIC CONNECTION OF THE INDOOR UNIT
WARNING!
Danger of breakdowns or malfunction. If the fuse
on the PC board is blown please change it with type
T. 3,15A/250V.
• Open the air intake vent (in case of floor-ceilings and
90X90 cassettes).
• Find the access to the electrical wiring (see Figures 5., 5.,
5.4 and 5.8) and remove the cover.
• Remove the plug-in joins between the body of the unit and
the cover.
• Remove the side cover of the connection box in the body
cover.
MONOPHASE UNITS
INDOOR UNIT
OUTDOOR UNIT
TRIPHASE UNITS
INDOOR UNIT
OUTDOOR UNIT
Fig. 13.1
Independent supply.
CASSETTE - FLOOR-CEILING - DUCTED UNITS
• Connect the line on the terminal strip of the indoor unit
according to the corresponding wiring diagram (see
Figures).
• Check that the cables are correctly secured and
connected.
• Place the wiring cover.
• Assemble the plug connections between the body and the
cover.
• Position the lining and close the air inlet grille.
to Controls:
SDSC-0
SDCC-0
to Controls:
SDSC-0
SDCC-0
Fig. 13.2 Single supply.
4
/ Installation Manual
13 ELECTRIC WIRING
MONOPHASE UNITS
INDOOR UNIT
to Controls:
SDSC-0
SDCC-0
OUTDOOR UNIT
TRIPHASE UNITS
INDOOR UNIT
to Controls:
SDSC-0
SDCC-0
OUTDOOR UNIT