Table of Contents
Advertisement
2. Daily care
• When possible, use the cleaning stick (SPC-0527) for cleaning around the head/ capping station/ wiper.
Using the other cotton bud may attach lint, then it may damage the machine.
• Be sure to perform maintenance for the ink cap and the wiper of capping station every day. If you leave it
dirty, dirt may adhere to the nozzle surface, or, dust and dry ink may be rubbed against the nozzle. It may
cause discharge defect.
• Clean the bottom of carriage every day so that it will not get dirt from inks or dusts. If you leave it dirty, dust
and dry ink may be rubbed against the nozzle at wiping operation when performing head cleaning.
• When you clean the carriage bottom surface, fully be careful not to rub the nozzle surface.
(1) Surroundings of the heads ("Cleaning the Head and the Area around It" Chapter 4 of
the Operation Manual)
• The heads and their surroundings are the parts most liable to be tainted in this machine and if
tainted, it could cause adverse effects to the functions of the machine and the results of the printings.
Moreover, as the head itself uses very fine mechanisms, sufficient precautions are required for the
care and maintenances.
1
Move the carriage to the left and open the left
maintenance cover.
• Refer to the Step 1 to 5 of Chapter 4 "Cleaning the Head and
the Area around It" of the user's manual to perform the
operation.
2
Hold The Handle And Shift The Flushing Unit.
• Refer to the Step ６ of Chapter 4 "Cleaning the Head and the
Area around It" of the user's manual to perform the operation.
3
Soak the clean stick or the waste cloth
in the maintenance cleaning liquid and
wipe off an accumulated ink on the side
of the head and on the bottom surface of
the slider.
• Never rub the nozzles.
Clean the side surface of the
head (shown in deep gray)
with a clean stick.
The nozzle part
(Never touch it.)
2
Left side
Screw
maintenance cover
clasp
Handle
Clean with a clean stick or a
waste cloth.
Advertisement
Table of Contents
