Table of Contents
Advertisement
68
6.4 Data register content
6.4.1 Access rights
The "access" column in the tables in the following chapter describes which
lock must be opened in order to change a parameter. All parameter chan-
ges are saved in a log.
Access Meaning
C
Calibration officer
6
CDL
Certification data log
A
Administrator
Cu
Customer
-
No access
6.4.2 "Main" register (main display)
An overview of the most important measurements is presented in the
"Main" register. The contents may vary depending on the parameterization
( chapter 6.4.6.5).
It is not possible to move the cursor to a value in this register
the "ENTER" button, the displayed values are updated.
Display
Meaning
Vb
Volume at base conditions
Vm
Volume at measurement conditi-
ons
P
Pressure
K
Compressibility ratio factor
T
Temperature
C
Conversion factor
6.4.2.1 Vb – Volume at base conditions
The volume measured by the connected gas meter will be converted into a
quantity at base conditions and totaled in this counter.
If there is a fault (see chapter 8 "Faults"), the Vb counter will be stopped
and the volume will be totaled in a special disturbance quantity counter.
6
If a configuration log is in a device.
7
The exception is if the „Main" tab was set to „List" (see chapter 6.4.6.5).
7
. By pressing
Unit
Access Address
3
m
C
3
m
C
bar
-
-
-
°C
-
-
-
Operation
2:300
4:300
7:310_1
8:310
6:310_1
5:310
Advertisement
Table of Contents
