Elster GmbH
4
Data Communication
4.1
Local TCP/IP Data Communication
The main Data Communication Port of the EnCal 3000 Quad is the TCP/IP port, although 2 serial ModBus ports are also
available (see next paragraph). The TCP/IP Port (Ethernet UTP 10 Base-T) is necessary for connection with RGC 3000
(Windows based interface for configuration, diagnostics and report generation), but is also used by preference for
ModBus communication with Flow Computers, DCS systems, PLC and other ModBus hosts, if they are able to handle
ModBus TCP/IP. If not, ModBus serial to TCP/IP are easily available nowadays. For existing systems the 2 serial ModBus
ports can of course also be used.
The picture below shows a typical set-up:
fig. 4-1 Typical Data Communication Set-up for Ethernet Communication with the EnCal 3000 Quad
___________________________________________________________________________________________________________
EnCal 3000 Quad– Hardware Manual
16/09/2014
33/51