Table of Contents
Advertisement
3.3 Submenus
Skipping into the submenu occurs by pressing the key for at least two seconds.
3.3.1 Status register
AD
Address Designation / value
SR.SY
2:101
System status register
SR.1
1:111
Status Register 1
SR.2
2:111
Status Register 2
SR.5
5:111
Status Register 5
SR.6
6:111
Status Register 6
The messages displayed in the status register S.REG can be found in the system status
register SR.SY and in the status registers SR.1, SR.2, SR.5 and SR.6. Their meanings are
described in Chapters 3.3.1.1 and 3.3.1.2.
SR.SY System status
Here, messages can be found which generally relate to the TC210 system
(→ 3.3.1.1).
SR.1
Status Register 1
SR.2
Status Register 2
SR.5
Status Register 5
SR.6
Status Register 6
Here, messages can be found which affect the inputs, outputs, temperature meas-
urement and conversion factor (→ 3.3.1.2).
3.3.1.1 Messages in the system status (SR.SY)
1
Restart
The device was started without usable data. Counter readings and archive are
empty, the clock has not yet been set.
3
Data restored
The device was temporarily without any power supply. Possibly during battery re-
placement, the old battery was removed before the new one was connected. Data
has been retrieved from the non-volatile memory (EEPROM).
The retrieved counter readings and the clock values are possibly out of date:
If a manual data backup was carried out with the command "Save" before the voltage
failure (→ 3.3.3), the counter readings and clock values correspond to the state at the
time of the data backup.
Without manual data backup, the counter readings and clock values are retrieved
with the state at the end of the last day before the voltage failure.
ELSTER HANDEL GmbH
TemperatureVolume Corrector TC210
Unit
-
-
-
-
-
(For legend see page 28)
Access
DC
-
19
-
19
-
19
-
19
-
19
(Alarm)
(Warning)
33
Advertisement
Table of Contents
