6-6. ADF Roller and Contact Image Sensor (CIS)
1. Before disassembling the roller and CIS, you
should remove:
Ð Rear Cover (see page 6-2)
Ð Top Cover (see page 6-3)
2. Remove the ADF roller. When you assemble the
roller, make sure it is properly hooked.
Note : Clean the surface of the roller with ethyl
alcohol. After wiping it, you must dry it
completely.
Samsung Electronics
3. Unplug the CIS harness, then remove the CIS
assÕy. To remove the CIS assÕy, turn it up and
slide the two legs far left, and pull it up.
4. Remove the CIS from the bracket.
Note: Check the glassy surface of the CIS for stains
or scratches. If stained, wipe off with ethyl
alcohol. If it is heavily scratched, replace it
with a new one.
Disassembly and Reassembly
CIS
6-5