Table of Contents
Advertisement
6. Disassembly and Reassembly
6-1. General Precautions on Disassembly
When disassemble and reassembling components, use extreme caution. The close proximity of cables to moving
parts makes proper routing a must. If components are removed or replaced, any cables
disturbed by the procedure must be replaced as close as possible to their original positions. Before removing
any component from the machine, note the cable routing that will be affected.
Whenever servicing the machine, you must perform the following:
1. Check that documents are not stored in memory.
2. Remove the print cartridge.
3. Unplug the power cord.
4. Work on a flat and clean surface.
5. Replace only with authorized components.
6. Do not force plastic components.
7. Make sure all components are in their proper position.
6-2. White Roller
1. Lift the control panel.
2. Push the white clip on each end of the roller
slightly inward, then rotate it until it reaches the
slot, as shown below. Then lift the roller out.
white clip
Control panel
Samsung Electronics
Note : Check the roller for dirt. If dirty, wipe it off
B
A
White roller
with soft cloth dampened with water. If the
roller is heavily worn, replace it with a new
one.
6-1
Advertisement
Table of Contents
