Display Features 2; Inspect 2 - AT&T Definity 7406 Plus User Manual

In normal mode, the display shows call information for the current active call
appearance button:
You may have as many as 5 call appearance buttons. Beginning with the first
button in the upper left hand corner of your faceplate and going down, the display
identifies the first 3 buttons as a, b, and c; the 2 buttons in the second column
are identified as d and e. When the display shows [
information for the first call appearance button. The next button down would be
shown as [ ] , and so on, continuing through [
b=
buttons are used for call appearances.
When you dial an extension, that number is shown then replaced by the called
party's name and extension.
When a call is received from another extension, the caller's name is shown; when
a call is received from outside, [
The display remains in normal mode until you activate one of the other display
features. After using any of these features, return to normal mode by pressing
[ ] .
Normal
Inspect
To see who's calling
while on a call
To see who's on hold
while on a call
To answer new call
while on a call
Display Features
] or a trunk identifier is shown.
OUTSIDE CALL
1 Press [ ]
Inspect
Name and number of caller shown if from
extension; [
OUTSIDE CALL
shown if from outside
Note: New caller information is shown for 30
seconds when call is received; then display returns to
normal mode.
Press [ ]
1
Inspect
Press [ ] of held call
2
xxxxx
You remain connected to present call
1 Press [ ] (if not already in normal mode)
Normal
Finish present call or put on hold
2 Press [ ] of new call
xxxxx
] it represents call
a=
] if all 5 of these
e=
] or other trunk source
2 9