Volume Of Water Used In The Water Saver Option; Out Of Balance Recovery; To Program The Automatic Out Of Balance Recovery - Fisher & Paykel GWL03US Service Manual

6.4 VOLUME OF WATER USED IN THE WATER SAVER
OPTION
You can increase or decrease the volume of water used during the Water Saver option.
1. Select the OPTION ADJUSTMENT MODE by pressing and holding down the
START/PAUSE button, then pressing the POWER button.
2. Use the WATER LEVEL buttons to select the water volume.
HIGH LED ON
MED. LED ON
LOW LED ON
3. Press POWER button to return to normal operation.

6.5 OUT OF BALANCE RECOVERY

If the washer senses an unbalanced load it will stop and give a short burst of beeps every five
seconds and the RINSE or SPIN LED will flash. As well as the current SPIN SPEED LED. The
load must be redistributed and the washer restarted manually.
The washer can also be programmed to automatically correct an out of balance load. If it detects an
unbalanced load, it will fill with water and agitate for a number of minutes. This will redistribute
the load before the washer tries to spin up again. If this action does not clear the out of balance load
after a few attempts the washer will stop.

TO PROGRAM THE AUTOMATIC OUT OF BALANCE RECOVERY

1. Select the OPTION ADJUSTMENT MODE by pressing and holding down the
START/PAUSE button, then pressing the POWER button.
2. Use the HEAVY DUTY button to select the Out of Balance recovery option.
HEAVY DUTY LED ON
HEAVY DUTY LED OFF
3. Press POWER button to return to normal operation.
more water
normal – Factory Setting
less water
automatic
stops and sounds warning
23