How To Replace The Vacuum Belt And Headlight Bulb - Carpet Pro CPU-1QD Owner's Manual

How to Replace the Vacuum Belt
CAUTION: Unplug the vacuum cleaner before performing any of
these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position by pressing the foot
pedal release twice while reclining the handle. Turn the vacuum over.
2. Remove the two screws holding the bottom plate in place (Fig. 1).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the vacuum cleaner over and remove the bottom plate as
described in the above section.
2. Remove the belt guard (Fig. 2). Remove the brushroll by pulling it
straight out (Fig. 3).
3. Remove the belt from the brushroll.
4. Loop a new belt over the motor pulley (Fig. 4) and over the end of
the brushroll.
5. Stretch the belt while inserting the brushroll back into the nozzle
housing.
6. Reinsert the belt guard.
7. Spin the brushroll by hand to make sure it turns smoothly and the
new belt is properly aligned.
8. Replace the bottom plate by hooking the front end of the plate into
the two ribs on the front end of the nozzle housing. Press the bottom
plate into place and fasten it with the two screws.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly
to ensure it is in good condition. Replace the belt if it is stretched,
cracked or if excessive slipping is occurring.
How to Replace the Headlight Bulb
How to Replace the Headlight Bulb (Fig. 5)
CPU-1QD, CPU-1 and CPU-1T models only
1. Turn the vacuum cleaner over and remove the bottom plate as
described in the above section.
2. To remove the bulb, grasp it gently and pull it straight out.
3. Install a new bulb by pushing it straight into the socket.
4. Replace the bottom plate as described in the above section.
10
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5