Thermal Fuse Protection; Optional Cleaning Tools/Accessories - Carpet Pro CPU-1QD Owner's Manual

Your Carpet Pro vacuum cleaner comes equipped with a Manual Reset Thermal Fuse Protector. This thermal
protector is designed to protect your vacuum cleaner from overheating due to a cutoff in airflow (i.e.
clogged hose, operating the vacuum without a bag). Should this situation occur, the thermal fuse protector
will safely shut off your vacuum cleaner to avoid any potential damage.
Models: CPU-1QD, CPU-1 and CPU-1T
NOTE: To determine if it was the thermal fuse protector that turned off your vacuum cleaner and not some
other reason, please refer to the vacuum cleaner's headlight. If the headlight is on while the motor is off,
then the thermal fuse did safely shut down the motor. If the headlight and motor are off, then there is
some reason other than the thermal protector (i.e. pulled plug) the vacuum cleaner has shut down.
To Reset the Thermal Fuse
1. Unplug the vacuum cleaner.
2. Check for problem (over-filled bag, clog in hose, clogged filters, etc.).
3. Correct problem.
4. Locate "tripped" fuse — the small red or white button located on the lower left side on the back of the
main body (roughly one inch to the right of the left wheel).
5. Using a pencil, paper clip, or other pointy object, push the reset button.
6. Plug vacuum cleaner in and begin using.
Please return to a Carpet Pro Service Center if the problem continues or if you have any questions.

Optional Cleaning Tools/Accessories

7-Piece Deluxe Attachment Kit Part #05.119 (Fig. 1)
15-foot crushproof hose with curved handle
Extension wand (2 pieces)
Dusting brush
Crevice tool
Upholstery tool
Upholstery brush insert
Deluxe floor brush
6- Piece Standard Attachment Kit #05.123 (Fig. 2)
7-foot hose with curved handle
Extension wand (2 pieces)
Dusting brush
Crevice tool
Upholstery tool
Upholstery brush insert
Connecting the Hose Assembly to the Vacuum Cleaner
Open the lid located on the back side of the vacuum cleaner and
insert the plastic end of the hose assembly into the accessory
attachment opening (Fig. 3). Attach wands and tools to the
hose handle as needed.

Thermal Fuse Protection

9
Fig. 1
Fig. 2
Fig. 3