How To Replace The Vacuum Belt And Headlight Bulb - Carpet Pro CPU-1 Operating Instructions Manual

How to Replace the Vacuum Belt and Headlight Bulb

CAUTION: Unplug the vacuum cleaner before performing any of
these steps.
How to Remove the Bottom Plate
1. Place the vacuum cleaner in the low position by pressing the handle
release pedal twice. Turn the vacuum over.
2. Remove the two screws holding the bottom plate in place (Fig. 1).
3. Remove the bottom plate.
How to Replace the Belt
1. Turn the unit over and remove the bottom plate as described in the
above section.
2. Remove the belt guard (Fig. 2). Remove the agitator by pulling it
straight out (Fig. 3).
3. Remove the belt from the agitator.
4. Loop a new belt over the motor pulley (Fig. 4) and over the end of
the agitator.
5. Stretch the belt over the agitator while inserting it back into the
nozzle housing.
6. Reinsert the belt guard.
7. Replace the bottom plate by hooking the front end of the plate into the
two ribs on the front end of the nozzle housing. Press the bottom plate
into place and fasten it with the two screws.
NOTE: To ensure maximum cleaning efficiency, check the belt regularly to
ensure it is in good condition. Replace the belt if it is stretched,
cracked or if excessive slipping is occurring.
How to Replace the Bulb (CPU-1 and CPU-1T models only) (Fig. 5)
1. Turn the unit over and remove the bottom plate as described in the
above section.
2. To remove the bulb, grasp it gently and pull it straight out.
3. Install a new bulb by pushing it straight into the socket.
4. Replace the bottom plate as described in the above section.
8
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5