Related Manuals for Carpet Pro CPU-75
Summary of Contents for Carpet Pro CPU-75
-
Page 1: Operating Instructions
OPERATING INSTRUCTIONS FOR CARPET PRO UPRIGHT VACUUMS MODELS : CPU-75, CPU-75T, CPU-85, CPU-85T Before operating the vacuum, please read these instructions completely. -
Page 2: Table Of Contents
Save These Instructions Before you plug in your Carpet Pro vacuum cleaner, make sure the voltage indicated on the rating plate located underneath the vacuum cleaner is the same as your local supply�... -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE� This machine is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the machine by a person responsible for their safety�... -
Page 4: Two-Wire Polarization/Three-Wire Polarization
Two-Wire Polarized Cord MODELS: CPU-75 AND CPU-75T This product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other)� This plug will fit into the power outlet only one way� This is a safety feature�... -
Page 5: Parts Identification
Furniture guard Thermal reset Self-adjusting nozzle button Replacement Bags and Filters • Genuine Carpet Pro Foam Filter • Genuine Carpet Pro Vacuum Bags Part number 06.265 Part number 06.144 6 per package • Genuine Carpet Pro Secondary Filter Part number 06.250... -
Page 6: How To Assemble And Operate The Vacuum
How to Assemble and Operate the Vacuum How to Attach the Handle to the Vacuum Cleaner The vacuum and the handle are packed separately� 1� After first removing the handle screw, slide the handle into the slots on top of the vacuum cleaner� (Fig� 1) 2�... -
Page 7: Handle Adjustments
Handle Adjustments The handle on this vacuum cleaner can be set to one of three positions – upright, middle or low� How to Adjust the Handle 1� To release the handle, step on the foot pad on the top left of the vacuum cleaner (Fig�1)�... -
Page 8: Automatic Self-Adjusting Rug Nozzle
Automatic Self-Adjusting Rug Nozzle Your Carpet Pro upright vacuum cleaner is designed with an Automatic Self-Adjusting Rug Nozzle� No manual adjustments are required� The height of the rug nozzle is instantly and automatically adjusted to carpet pile height� This self-adjusting feature allows the rug nozzle to float evenly over all carpet pile surfaces�... -
Page 9: How To Replace The Headlight Bulb & Vacuum Belt
2� Remove the four screws holding the lower plate in place (Fig� 1)� 3� Now remove the bottom plate� Fig� 1 How to Replace the Bulb� MODELS: CPU-75 AND CPU-75T 1� Place vacuum cleaner in the low position by pressing the handle release pedal twice� Remove the bottom plate as described above�... -
Page 10: How To Clean The Nozzle Hose
NOTE: For models CPU-75 and CPU-75T, to determine that it was the thermal fuse protector that turned off your vacuum cleaner and not some other reason, please refer to the vacuum cleaner’s headlight� If the headlight is on while the motor is off, then the thermal fuse did safely shut down the motor�... -
Page 11: For Best Performance
• Change vacuum bags and filters as recommended to maintain optimum cleaning efficiency. • Always use genuine Carpet Pro vacuum bags, filters and parts as use of other products may result in poor cleaning or filtration performance� Carpet Pro filtration products are designed for maximum performance�...