Parameter "P0927" - Change Source For Parameters - Siemens MICROMASTER 420 Operating Instructions Manual

Information for the CANopen master
6.2 Parameter "P0927" – change source for parameters
This parameter can be set in order to define the sources of the parameter changes.
Bit 0
Bit 1
Bit 2
Bit 3
The pre-setting (default setting) for all bits is 1; this means that the parameters of
all of the sources can be changed.
106
CANopen master
BOP
Mounting set PC/drive converter
(USS at the BOP interface)
Local RS485 interface (terminal 14/15
(MICROMASTER 420) and 29/30
(MICROMASTER 440) with USS)
0: No
1: Yes
0: No
1: Yes
0: No
1: Yes
0: No
1: Yes
CANopen Option Module Operating Instructions
6SE6400-5BC00-0BP0
Issue 01/05