Wireless Pacific X10DR User Manual
Lite series
Hide thumbs
Also See for X10DR:
- Installation & setup instructions manual (69 pages) ,
- Installation and setup manual (46 pages) ,
- User manual (40 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Wireless Pacific X10DR
Summary of Contents for Wireless Pacific X10DR
- Page 1 User Manual Lite Series...
-
Page 2: Table Of Contents
CONNECTING XMC-RJ45/XIC-1.5 INTERFACE CABLE. The standard supplied XMCA 1/4 wave stub antenna, can be fitted directly to the base of the X10DR Lite Gateway cradle when only limited range is required. For optimum range performance it should be mounted on the supplied L Bracket... - Page 3 “out of range” or when its paired unit is turned off. for best performance Antenna Connector: Allows connection of longer range Note: Your X10DR will provide longer external antenna or replacement of the short range internal type. range when worn with the antenna protruding above your shoulder.
-
Page 4: Operational Description
X10DR has since its launch in 2012 re- defined mobile network design by increasing user mobility whilst dramatically improving the effectiveness of your infrastructure investment. -
Page 5: Basic Operation
Out of Range Indication being lost, it can be permanently erased from the Gateway X10DR Lite provides the user with feedback should the user move out by master resetting. You can do this by turning it off and then of range from their vehicle. If you walk out of range the blue status holding the On button for about 10 seconds until the LED LED will flash. -
Page 6: Battery Charging
After replacement, the X10DR Lite Wireless Microphone should be first placed back into the mobile charger and Simply place the mic into charging cradle and the X10DR Lite will beep charged for 4 hours prior to commencement of use. (In some to show correct placement. - Page 7 It is factory set for nominally 80mV RMS. IMPORTANT: If required Adjust VR1 so X10DR audio matches the level from the radio’s mobile mic. VR1 is preset for 80-100mVRMS output.
- Page 8 Spare Radio Interface cable adaptor. (see over) XIC-1.5 Spare 1.5m shielded Cat 6 cable, Black M-M. XEC-4.5 4.5m shielded Cat 6 extension cable, Black M-F. XMC-RJ45 Spare DB15F to RJ45F Cable Adaptor for X10DR Lite. XSMA Spare handset antenna XMCA Spare gateway antenna XMC-RJ45 XIC-1�5...
-
Page 9: Warranty
Changes or modifications to this product not under the warranty. If an X10DR has been submerged in water, punctured, or authorized by Wireless Corporation Ltd could void the FCC Certification and subjected to a severe fall, do not use it until you take it to an WCL Authorized negate your authority to operate the product. -
Page 10: Important Safety And Handling Information
United et le Japon, les émetteurs sans fil et les circuits électriques dans le X10DR peut provoquer des interférences avec d’autres équipements électroniques. Par conséquent, s’il vous plaît prendre les States, Canada, the European Union, and Japan, the wireless transmitters and précautions suivantes:... -
Page 11: Proper Care And Handling
To charge X10DR, use only the WCL mobile or desktop charger. An external antenna is connected to the output connector on the mobile When you use the WCL desktop charger to charge X10DR, make sure that the charger. Always keep your body at least 20cm (8”) from the vehicle mounted power adapter is fully assembled before you plug it into a power outlet. - Page 12 Battery Type: 3.7V @1450mA Lithium Polymer Air Bag Equipped Vehicles: An air bag inflates with great force. Do not store X10DR or any of its accessories Battery Life: >15 Hours @ 30% receive time in the area over the air bag or in the air bag deployment area.
- Page 13 X10DR ® All rights reserved Wireless Corporation Limited ©2018 Wireless Pacific, X10DR, X10DR Lite and their logos are trademarks or regis- tered trademarks of Wireless Corporation Limited : Manual revision O...
Need help?
Do you have a question about the X10DR and is the answer not in the manual?
Questions and answers