Preparation For Measurement; Installing Batteries - Kanomax ANEMOMASTER LITE 6006 User Manual

§ 2

Preparation for Measurement

Installing Batteries

＜Back (Battery Case)＞
Preparation for Measurement
8
Use four AA size batteries.

Make sure that the power is off before inserting the batteries.

If you are using charging batteries, charge them with a special

charger prior to use.
1. Slide the cover of the battery case down
2. Slide the cover until it stops, and then lift it
＋ -
3. Insert the batteries in the order shown in
１ ２
4. Replace the battery cover by following the
-
＋
＋ -
３ ４
-
＋
along the rail.
up.
the left figure, observing polarity.
reversed procedures 1 and 2.
To put the battery cover back,
do not first engage the detent
at the top end.
Follow the above-mentioned
procedure backwards to slide
the cover back.
If you forcibly try to click the
cover onto the body, it may
be broken.