Advertisement
Start-Up & Operation
New Installation/Seasonal Start-Up
1.
Close drain plug at the base of filter.
2.
Secure and lock Easy-Lok™ ring.
3.
Open air vent valve (Rotate the knob counterclockwise).
4.
Open valves (Optional suction & return valves).
WARNING
outlet valves can cause severe personal injury and/or property damage. OPEN all suction
and outlet valves before operating the filter system.
Prime and start the pump per manufacturer's instructions.
5.
6.
Once air has escaped the filter and a steady stream of water is flowing from the air vent valve,
close the air vent by turning clockwise and note the pressure gauge reading.
Filter Disassembly & Assembly
Cleaning/Removing Cartridge Element
NOTICE: An indication that the filter needs cleaning is when the pressure gauge rises 5-7
PSI above its starting pressure.
1.
Shut off the pump.
2.
Close valves* (*optional: suction & return valves).
3.
Open air vent valve.
4.
Open drain plug (located at the base of the filter body).
5.
Depress safety latch (located on the underside of the locking ring handles) and unscrew locking
ring in a counter-clockwise direction. Remove lid from filter body.
6.
Lift out filter element and clean as instructed in "Preventative Maintenance" section of this
manual.
Re-Installing Cartridge Element
Clean debris from bottom of filter tank.
1.
2.
Replace element evenly on the collector hub in bottom of the filter body.
3.
Place lid evenly on filter body and turn Easy-Lok™ ring clockwise until the safety latch engages
securely.
4.
Close and secure drain plug (located at the base of filter body).
5.
Proceed as in "Start-Up & Operation".
Vacuuming
Vacuuming can be performed directly into the filter whenever needed. For fastest results, clean
the filter before and after each vacuuming. For heavy spring clean ups, we recommend using a
Hayward SP0727 diverter valve to bypass the filter and accelerate the clean up process. Consult
your local Hayward dealer for a detailed explanation
Winterization
In areas where sub-freezing temperatures can be expected, the filter should be drained and/or
removed from its operating location and stored indoors. Clean the cartridge element at the end
of the pool season by using the Hayward Jet-action Cleaning Wand (EC2024) or a garden hose.
(See "Cleaning Cartridge Filter" instructions in this manual.
COMPONENT SEPARATION HAZARD
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Failure to open all suction and
6
Advertisement
