Table of Contents
Advertisement
Disassembly Procedures
WARNING
Splatter Shield
NOTE: Be careful not to bend antenna when removing
splatter shield. Shield snaps into a lip in front of
the oven and three slots in the back.
1. Place your thumbs in the two indentations in front of
the shield.
2. Press lightly towards the back and carefully lower
shield away from antenna.
3. Pull shield out of the back slots and out of the oven.
Upper Antenna
1. Remove splatter shield from oven cavity.
2. Remove two mounting rivets on the top of oven
cavity to remove cradle. Support cradle before
removing mounting rivets to avoid damage to
antenna assembly.
Lower Antenna
1. Open oven door.
2. Using a suction cup to pry upward on front portion
and remove tray from unit.
3. Remove two mounting rivets on the bottom of oven
cavity floor to remove cradle. Support cradle before
removing mounting rivets to avoid damage to
antenna assembly.
26
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors before
following any disassembly procedure.
Stirrer Motor
1. Disconnect power to oven and remove outer case,
(see "Outer Case" procedure).
2. Remove outer case.
3. Disconnect the leadwire from the stirrer fan motor
terminals.
4. Remove screws securing stirrer motor to wave guide.
5. Replace component and and reverse procedure to
reassemble.
NOTE: When replacing stirrer motor, verify motor shaft
is aligned with antenna shaft before securing
with screws.
Lower Stirrer Motor
1. Lay the unit down on its back.
2. Remove the screw securing the base cover.
3. Remove the screw securing the stirrer fan motor to
the oven cavity assembly.
4. After repairing the motor, replace the removed
base cover.
5. The taptite screw shall be used when a turntable
motor cover is secured with a screw.
Taptite Screw
16400007 Rev. 0
Base cover
Wire Leads
Stirrer Fan Motor
©2010 ACP, Inc.
Advertisement
Table of Contents
