Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Straight & groove forming bits
Edge forming bits
Laminate trimming bits
Trimmer guide assembly
Templet guide 25
Templet guide adapter
1. Limit mark
1. Brush holder cap
Collet cone 12 mm, 1/2"
Collet sleeve 3/8", 1/4"
Collet sleeve 6 mm, 8 mm, 10 mm