Control
Introduction
The control menu allows the user to access the following functions of the Inverter:
● Setpoint
● Jog
● Reverse
The menu is selected by using the
the menu bar to the required menu.
Pressing
level menu.
The Inverter must be in HAND mode before any functions
can be accessed. If HAND mode is not selected a notice
screen is displayed stating that the Inverter is not in HAND
mode.
The HAND mode is selected by pressing the
Note
Hand/Auto mode
If the
Setpoint screen.
The individual functions are described below.
Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
will confirm the selection and display the top
key is pressed when the Inverter is in AUTO mode, the user is taken directly to the
and
keys to move
key.
7
23