Editing Parameters (Single Digit Method) - Siemens Sinamics BOP-2 Operating Instructions Manual

Image 9-2

Editing parameters (single digit method)

The scrolling editing is accomplished by scrolling through to the parameters until the required
parameter is displayed. Press the
parameter value starts to flash. Using the
parameter value. Press the
The actions required to perform the editing of parameters by scrolling is shown in the
following figure.
Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
key to confirm the parameter selection; the displayed
and keys increase or decrease the
key to confirm the value.
Parameters
35