Setpoint; Torque Setpoint; Setpoint Function - Siemens Sinamics BOP-2 Operating Instructions Manual

Control

Setpoint

The setpoint value determines the speed at which the motor runs as a percentage of the
nominal motor speed. It should be noted that this setpoint setting is only valid while HAND
mode is active. When the Inverter is set back to AUTO mode, the setpoint previously used in
AUTO mode becomes the valid setpoint.
Note

Torque setpoint

In HAND mode the torque setpoint (if the Inverter is in torque control mode) cannot be
directly modified using the setpoint speed function of the BOP-2; although the motor can still
be stopped and started using the
To change or modify the value of the setpoint, the actions shown in the following figure
should be performed:
Image 7-1

Setpoint function

24
and keys respectively.
Operating Instructions, 02/2016, A5E37143404B AA
Basic Operator Panel 2 (BOP-2)