Advertisement
3
3
Make preparations for cutting
1
Press the Card without Craft Paper
Backing onto the carrier sheet.
Peel off both the inside liner and the liner
strips on both sides from the carrier sheet
so that the entire adhesive surface is
visible.
Liner
Carrier sheet
Peel off the inside liner and the
liner strips on both sides
Press the Card without Craft Paper
Backing onto the adhesive surface of the
carrier sheet, making sure that the edges
of the card are parallel to the edges of the
carrier sheet.
(When pressing the card onto the adhesive surface,
be careful not to cause air bubbles or wrinkles in the
card.)
Card without
Craft Paper Backing
Adhesive surface
Carrier sheet
Let's try out the Craft ROBO
2
2
Load the printed sheet in your Craft ROBO and mount the blade, blade holder
Turn the lock lever to the left
(OPEN direction) to loosen the
clamp bracket.
C h e c k t h a t t h e y e l l o w b l a d e
adjustment cap has been attached
to the blade holder, and then
mount the blade holder in the Craft
Lock lever
ROBO. Turn the protrusion on the
Blade holder
holder 90 degrees to the right so
OPEN
CLOSE
that it fits against the protrusion on
the clamp bracket. Firmly insert the
blade holder in the clamp bracket
Upper surface of blade holder
and then turn the lock lever to the
right (CLOSE direction) to tighten
the clamp bracket.
C l i c k t h e " N e x t " b u t t o n . T h e
"Design Orientation" screen is
displayed. Click the "Next" button
Front
once again. The "Load Media"
Holder protrusion
screen is displayed.
Turn to this position
Blade holder
Blade adjustment cap
HINT
cap
media
Blue
For thin film
Yellow
For thick film, thin paper
For thick paper
Blade
Red
such as a postcard
Standby switch
Pinch rollers
Guideline
Load the printed sheet
following the printed
hint line "Feed this side
HINT
Protruding blade length
first".
(approx.)
0.1mm
0.2mm
0.3mm
8
Press the standby switch on the
Craft ROBO, and confirm that the
LED lamp on the switch is lit (blue).
Align the left edge of the sheet
with the vertical guideline indented
on the front guide. While making
sure that the sheet is straight, turn
the feed knob until the top edge of
the sheet touches both pinch
rollers.
Close the top cover.
Click the [Next] button to proceed
to the "Registration Marks" step.
Click the [Next] button again to
proceed to the "Start cutting" step.
Advertisement
