Advertisement
To Ensure Safe and Correct Use
1
Safety Precautions
Do not use or store the Craft ROBO in a
location exposed to direct sunlight or the
direct draft of an air conditioner or heater.
• Such location may impair the performance of
the Craft ROBO.
Prohibited
Do not use the Craft ROBO in an excessively
dusty or humid location.
• Such location may impair the performance of
the Craft ROBO.
Prohibited
Do not place any receptacle containing water
or other fluid on top of the Craft ROBO.
• Fluid falling inside the Craft ROBO may cause
electrical shock or a fire hazard due to current
leakage.
Avoid water
Beware of electrical shock
CAUTION
Do not use the Craft ROBO in a location
subject to excessive mechanical vibration or
electrical noise.
• Such location may impair the performance of
the Craft ROBO.
Prohibited
When disconnecting the power cord or an
interface cable, do not pull on the cord/cable.
• Such action will damage the cord/cable,
resulting in a fire hazard or electrical shock. Be
sure to hold the power cord's plug or the
interface cable's connector.
Prohibited
If water or foreign matter enters inside the
Craft ROBO, do not continue using it. Turn off
its power and unplug its power cord from the
electrical socket.
• Use of the Craft ROBO in such status may
result in electrical shock or a fire hazard due to
current leakage.
• Contact your sales representative or nearest
Graphtec vendor to request repair.
Unplug the power
cord from the socket
Do not attempt to lubricate the Craft ROBO's
mechanisms.
• Such action may cause it to break down.
Prohibited
Do not clean the Craft ROBO using a volatile
solvent such as thinner or benzine.
• Such action may impair its performance.
Prohibited
During cutting or plotting, provide enough
space around the Craft ROBO so that the
loaded sheet will not hit any objects in its
vicinity.
• Such contact may cause cutting or plotting to
go out of alignment.
Contact prohibited
When using indoor lighting such as a
fluorescent lamp or an electrical lamp,
provide a distance of at least one meter
between the Craft ROBO and the light source.
• Closer proximity of such a light source may
cause the sensors to malfunction.
When using the blade, blade holder, make
sure that the correct blade adjustment cap for
the selected Media Type is installed.
• An overly extended blade will damage the
cutting mat and adversely affect the cutting
quality.
Move the pen carriage slowly when moving it
manually in order to load the sheet for cutting
or for other reasons.
• Moving it quickly may damage the Craft ROBO.
4
Advertisement
