Advertisement
Usage Precautions for Media Used for Cutting
Graphtec only guarantees the cutting results for media supplied by Graphtec and cut under suitable conditions.
Please read all the following precautions carefully if you plan to use non-Graphtec media.
Media Type Precautions
Even if the media is thinner than the extended blade length, its thickness,
strength and the hardness of the fibers may cause it not to be cut through
completely. Please refer to the "Media is not cut properly" subsection of this
"When You Have Problems" section, or to the User's Manual that is included in
the CD-ROM, and then make the required adjustments. If the problem still
cannot be corrected, please use Graphtec-supplied media.
Precautions on Using Thin Media, and Media without a Protective Liner
When using thin media or media without a protective liner, the media is cut
right through and the cutting mat and blade may be damaged. Always affix
such media to the carrier sheet before cutting it.
Blade and Blade Holder Precautions
Both the blade and blade holder have a certain life expectancy. If the cutting
results deteriorate over time, please purchase a new blade.
Usage Precautions for
3
Media Used for Cutting
Precautions on Using Copy Paper
If copy paper is used
as is, the paper will
get caught up in the
Craft ROBO and
cause malfunctions.
Avoid using copy
paper wherever
possible. If you have
to use it, cut off the
top corners as shown
in the picture on the
right. Please note,
however, that the use
of copy paper may
void the warranty.
10 mm
3 mm
Copy paper
Sections cut off
The dimensions of the cut-off
sections are for reference only.
Please try different dimensions yourself.
14
Advertisement
