GRAPHTEC Craft ROBO CC200 Quick Application Manual page 13

4 4
Perform Cutting and Affix the Name
1 Perform cutting
Click
Click the [Cut] button.
[OK] button
Click the [OK] button to start cutting.
Do not touch the Craft ROBO during
the cutting operation.
When cutting has been completed,
remove the vinyl sticker. Turn the feed
knob to remove it.
2 Weed the name and affix
the application sheet
Use tweezers or a similar tool with a fine
point to weed the name (remove the
unwanted areas).
Affix the application sheet on top of the
design.
Let's try out the Craft ROBO
2
3 Transfer the characters to
the application sheet
After affixing the application sheet, rub it
firmly with a cloth or something similar to
transfer the cut characters onto the sheet.
Peel off the protective liner carefully so
that the cut characters remain affixed to
the application sheet.
4 Affix the name to the
desired item
Place the application sheet with the transferred
characters on the surface where you want to affix the
name. Rub it firmly with a cloth or similar to make sure
that the cut characters are affixed to the surface.
Carefully peel off the application sheet to
complete the process.
13