Setup And Assembly; Unpacking; Contents Of Shipping Container - Jet JTM-1 Operating Instructions And Parts Manual

8.0 Setup and Assembly

8.1 Unpacking

Open shipping container and check for shipping
damage. Report any damage immediately to your
distributor and shipping agent. Do not discard any
shipping material until the Turret Mill is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly for
assembly, maintenance and safety instructions.
NOTE: If your mill is supplied with an optional Table Powerfeed and/or Digital Readout, be sure to consult the
separate instruction materials that accompany them.

8.2 Contents of shipping container

Note: Some parts may be pre-installed on the mill.
1 Turret Mill (not shown)
1 Flat Way Cover
1 Pleated Way Cover
1 Draw Bar
3 Table Adjustment Handles
2 Belt Guards
1 Tool Box, containing (Figure 3):
1
1
1
1
1
1
1
1
1
1
1
1
* parts with an asterisk are also included in the tool
box service kit, p/n JTM4VS-TB.
Figure 3: shipping contents
9
Hex Key Set (1.5-10mm) *
17/19mm Box Wrench *
Cross Point Screw Driver #2 *
Flat Blade Screw Driver #2 *
Plastic Oil Bottle *
Elevating Crank Handle
Handwheel
Coarse Feed Handle
Can White Touch Up Paint
Hoisting Ring
Operator's Manual (not shown)
Warranty Card (not shown)