Jet JTS-8 Operating Instructions Manual

GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been
prepared for the owner and operators of a JET JTS-8 table saw to promote safety during installation, operation and
maintenance procedures. Please read and understand the information contained in these operating instructions and the
accompanying documents. To obtain maximum life and efficiency from your machine, and to use the machine safely, read
this manual thoroughly and follow instructions carefully.
...Table of Contents
1. Declaration of conformity
2. Warranty
3. Safety
Authorized use
General safety notes
Remaining hazards
4. Machine specifications
Technical data
Noise emission
Contents of delivery
Description of machine
5. Transport and start up
Transport and installation
Assembly
Dust connection
Mains connection
Starting operation
6. Machine operation
7. Setup and adjustments
Changing saw blade
Mounting the raving knife
Mounting the saw guard
Rising and tilting sawblade
Rip fence setup
Mitre gauge setup
8. Maintenance and inspection
9. Troubleshooting
10. Environmental protection
11. Available accessories
12. „Safe operation"........ appendix A
1. Declaration of conformity
On our own responsibility we
hereby declare that this product
complies with the regulations* listed
on page 2.
Designed in consideration with the
standards**. CE type
examination*** performed by****.
2. Warranty
The Seller guarantees that the
supplied product is free from
material defects and manufacturing
faults. This warranty does not cover
any defects which are caused,
either directly or indirectly, by
incorrect use, carelessness,
accidental damage, repair,
inadequate maintenance or
cleaning and normal wear and tear.
Guarantee and/or warranty claims
must be made within twelve months
from the date of purchase (date of
invoice). Any further claims shall be
excluded.
This warranty includes all guarantee
obligations of the Seller and
replaces all previous declarations
and agreements concerning
warranties.
The warranty period is valid for
eight hours of daily use. If this is
exceeded, the warranty period shall
be reduced in proportion to the
excess use, but to no less than
three months.
Returning rejected goods requires
the prior express consent of the
Seller and is at the Buyer's risk and
expense.
Further warranty details can be
found in the General Terms and
Conditions (GTC). The GTC can be
viewed at www.jettools.com or can
be sent by post upon request.
The Seller reserves the right to
make changes to the product and
accessories at any time.
3. Safety
3.1 Authorized use
This machine is designed for
sawing wood, wood derived
materials as well as similar to be
machined hard plastics only.
3
Machining of other materials is not
permitted and may be carried out in
specific cases only after consulting
with the manufacturer.
No metal work pieces may be
machined.
The workpiece must allow to safely
be loaded, supported and guided.
The proper use also includes
compliance with the operating and
maintenance instructions given in
this manual.
The machine must be operated only
by persons familiar with its
operation, maintenance and repair
and who are familiar with its
hazards.
The required minimum age must be
observed
The machine must only be used in
a technically perfect condition.
When working on the machine, all
safety mechanisms and covers
must be mounted.
In addition to the safety
requirements contained in this
operating instructions and your
country's applicable regulations,
you should observe the generally
recognized technical rules
concerning the operation of
woodworking machines.
Any other use exceeds
authorization.
In the event of unauthorized use of
the machine, the manufacturer
renounces all liability and the
responsibility is transferred
exclusively to the operator.
3.2 General safety notes
Woodworking machines can be
dangerous if not used properly.
Therefore the appropriate general
technical rules as well as the
following notes must be observed.