Datamars R-IN1300 MID User Manual page 9

*tt[_]
*ip[_-_-_-_]
*if
*rg[_]
*re[_]
ISO 15693 settings
ISO 15693 settings
*rm[_]
*mt[_]
*tm[_]
*mi[_]
*ts[_]
*qm[_]
R-IN1300 MID Manual – v. 1.2 – August '08
*cl0 16 characters UIDs (standard, default)
*cl1 15 characters UIDs (Partial code)
*cl2 14 characters UIDs (Partial code)
*cl3 13 characters UIDs (Partial code)
*cl4 12 characters UIDs (Partial code)
*cl5 12 characters UIDs (First character special)
*cl6 11 characters UIDs (Partial code)
*cl7 10 characters UIDs (Partial code)
*cl8 9 characters UIDs (Partial code)
*cl9 8 characters UIDs (Partial code)
Attention: code maybe not unique with the selected code length
Tag technology:
*tt1 tag technology ISO 15693(T-BT1320 T-BT1315) (default)
*tt2 tag technology Philips I-Code I (not available).
Example:
*it1: only ISO
*it2: only I-Code I
*it12: both ISO and I-Code I
Configure the IP (Internet Protocol) number of the reader.
Example:
*ip192-168-1-0
Sets the IP number 192.168.1.0
The default IP number of any new reader is 192.168.0.85
Plots the current (TCP/IP) network configuration of the reader
Receiver gain (in case of doubt, do not modify):
Amplification of the received signal.
*rg0, *rg1, *rg2 (default), *rg3: allowed amplification steps
Reverse order
*re0 Uid not reversed (default)
*re1 Uid recersed
Explanation
Reader request rate:
*rm0 Reader Request Rate: SLOW (1 out of 256)
*rm1 Reader Request Rate: FAST (default) (1out of4)
Modulation type:
*mt0 modulation type ASK
*mt1 modulation type FSK (default)
Tag response rate:
*tm0 Tag Response Rate: SLOW
*tm1 Tag Response Rate: FAST (default)
Modulation index:
*mi0 modulation index 20% (default)
*mi2 modulation index 100%
Time slots ISO-15693:
*ts0 single time slots
*ts1 16 times slots (default)
Quiet mode:
When this mode is enabled the transponder will answer just once
8 (29)