Page 1
THERMO POT MODEL: ETP-C5084(GR) Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
Return the appliance to the nearest authorized service center for examination, repair or adjustment. 6. The use of foreign accessory attachments that are not supplied by ELBA is not recommended as it may result in fire, electric shock or personal injury.
Page 3
WARNING To protect against electric shock, do not Do not place the appliance on unstable immerse the appliance, power cord or plug in surfaces. Always use the appliance on a flat, water or any other liquids. stable and heat resistant surface. This appliance is for boiling water only.
CONTROL PANEL HOW TO ATTACH AND REMOVE THE LID Detaching Lid Place the handle towards the rear side of the appliance. Open the lid by lifting the lid opening lever (beware of hot steam emitted from the water tank and steam vent). Position the lid at a 45...
OPERATING THE APPLIANCE To open the lid Do not fill the water more than the full line Place the appliance on a flat and stable marking. Please refer to the maximum water surface and fill up the water tank with water. level marking under the product descriptions.
Page 7
Temperature settings chart Note: It is recommended to adjust the Ideal temperature setting is at 85C. For other temperature to 85C after selecting the temperatures, they can be set by pressing the temperature at 98C or 60C (press the “TEMP. SET” button to select the desired “TEMP.
Page 8
To refill water Boiling water below the “REFILL” line may When the water level drops to the “REFILL” cause malfunction to the appliance. line, add water for automatic boiling. Refer to the water level indicator for the marking. To reboil water under keep warm mode 1.
AUTO-CUT OFF FUNCTION 1. When the water boil-dry, the appliance will automatically cut off the power. 2. The auto cut-off function will also operate when: The power is switched on, but no water inside the water tank. Water level is below the “REFILL” line. Refer to the water level indicator for the marking. CLEANING AND MAINTENANCE Always allow the appliance to cool down before cleaning.
6. Fill water until the water level reaches full line marking. Let the appliance to boil and retain the heat for about one hour. 7. Pour out the water and use a nylon brush to clean the water tank. 8. To remove the smell of the lemon, fill the water until the water level reaches the full line marking and boil the water again, then dispose all the boiled water.
Need help?
Do you have a question about the ETP-C5084(GR) and is the answer not in the manual?
Questions and answers