Product Preview; Preview Questions; Key Things To Know / Do - Cornelius XAC 1444 Service Training Manual

Xtreme Ice Training Manual

PREVIEW QUESTIONS

Check your current knowledge by taking a few minutes to answer the following questions:
1. Does the ice machine need to be level?
_____ Yes _____ No?
2. What is the recommended clearance for a air cooled machine?
________________________________________________________________________________
____________________________
3. What kind of cleaner should be used when cleaning this ice machine?
________________________________________________________________________________
_______________________
4. Water filters are required in most installations?
_____ Yes _____ No?
5. Water regulators are required in most installations?
_____ Yes _____ No?
6. What initiates the harvest cycle? ____________________________________________
________________________________________________________________________________
_________

KEY THINGS TO KNOW / DO

S This is a batch harvest system.
S The sealant should be added before the unit is placed on the dispenser or bin. Always seal the ice
maker to the bin (with a gasket or food grade sealant). Sealing prevents melted ice from running out
of the joint between the ice machines!
S Choose the proper condenser for the application:
Air – with sufficient clean air circulation.
Water – high ambient temperature or dusty environment, restricted air flow, or where extra BTUs are
un–wanted.
Remote – when heat or noise are a problem!
S Always refer to serial plate for electrical power requirements and refrigeration charge and type of
refrigerant!
NOTE: Note serial plate locations. Lower left–hand corner of cabinet, inside the unit on the bulk-
head between the evaporator and the compressor.
S Always use proper size and type of water conditioning equipment (filter, chlorine, etc.)!
S Do NOT use softened or reverse osmosis water!
S There is a manual reset high pressure cut out on the 500 series units.
S Installation of a bin thermostat control is required in some installations, such as ice drink dispensers
or ice drink unit!
S Bin stat is available to lower ice level! Part No. 630000408.
NOTE: If there is a very large slab of ice on the evaporator you will need to push the manual har-
vest button to remove it.
October 17, 2005

PRODUCT PREVIEW

1 TP00952