P
Q
REVIEW
UESTIONS
Check your current knowledge by taking a few minutes to answer the following questions:
1.
How many thrust bearings are in each IMD/WCC/WCF unit?
__________________________________________________________________
__________________________________________________________________
2.
How many manual reset overloads are in each IMD/WCC/WCF unit(s)?
__________________________________________________________________
__________________________________________________________________
3.
What type of water filters should be used on a Wilshire Ice Maker?
__________________________________________________________________
__________________________________________________________________
4.
What is the difference between Cubed and Extruded Ice Makers?
__________________________________________________________________
__________________________________________________________________
K
T
T
K
EY
HINGS
O
•
Rotational Freeze is the primary cause of evaporator squealing noises in units.
•
What is the proper water level setting.
•
How do you adjust low water safety switch.
•
How do you adjust ice level switch on IMD Series.
•
Why are there vertical groves (sanding) on the interior wall of the evaporator.
•
Water quality is very important!
•
Understanding control and safety switches!
•
Refrigeration gauges used only when absolutely necessary!
•
On the larger IMD units it is important to understand the function of the dispense timer.
© 2003, IMI Cornelius Inc.
INTRODUCTION
/ D
NOW
O
Cornelius Ice Makers Training Manual
- 1 -
Publication Number: TP00967