Operation; General Information; Operating Sitrans Lr 400 - Siemens sitrans LR 400 Instruction Manual

Operation

General Information

You can operate SITRANS LR 400 with:
• Hand-held infrared programmer
• Hand-held HART Communicator
• PC/Laptop and SIMATIC PDM software via HART or PROFIBUS PA
Notes:
• SITRANS LR 400 can be operated and programmed easily with SIMATIC
PDM software. This software gives you the added possibility of saving and
archiving your application-specific parameters and copying them back into
the device if necessary.
• It is best to perform the operations described in the following sections
directly on the device to familiarize yourself with the operation.

Operating SITRANS LR 400

Use the arrow keys at the bottom of the hand programmer to program SITRANS LR 400.
The two-line LCD displays the parameters. You can alter the setting or change to other
parameters using the arrows on the hand programmer (see page 20 for information on
navigating the menus using the arrow keys).
Hand Programmer
Note: The ARROW buttons shown below are required for programming
this product. The additional buttons on the hand programmer do not
apply to SITRANS LR 400.
SITRANS LR 400
buttons
Page 18 SITRANS LR 400 (Solids) – INSTRUCTION MANUAL
C
Key Programming Mode
Parameter scroll UP
Parameter scroll DOWN
LEFT Arrow (or CANCEL)
RIGHT Arrow (or ENTER)
7ML19985JC02