Table of Contents
Advertisement
Enclosure Assembly and Cleaning
Cable Cover Installation
1. Connect power, control, and video cables before installing the cable cover.
2. Align the cable cover to the cable well recess on the back of the display.
3. Slide the cable cover forward into the recess, with cables positioned under the cut-out.
4. Slide the cable cover forward until tabs on the bottom edge click into place.
Cleaning Instructions
General maintenance information
EndoVue series monitors do not require any scheduled maintenance or calibration activities. If any abnormal
situation found, please return the display to our approved maintenance organization. For any questions, please
call Customer Service for assistance at (877) 637-1110.
Warning: Prior to cleaning, the display should be turned OFF and disconnected from the power source.
• Do not allow liquids to enter the interior of the unit, as severe damage to the unit can result.
• Do not use solvents such as benzene or thinner, or any acid, alkaline or abrasive detergents.
Front Glass: Thoroughly wipe the front glass surface with a lint-free cloth. For persistent spots or smudges, use a
lint-free cloth dampened with distilled water. Do not use any harsh solvents, abrasive detergents or chemical
cleaning cloths.
Plastic Enclosure: Wipe all exterior surfaces with a lint-free cloth dampened with distilled water or a mild glass
cleaner such as 70% isopropyl alcohol, Vinegar (distilled white vinegar, 5% acidity). If a mild glass cleaner is used,
remove any residual cleaning material by wiping all exterior surfaces with a lint-free cloth dampened with
distilled water afterwards.
Note: Do not use the following products:
• MEK (Methyl Ethyl Ketone)
• Toluene
• Acetone
• Benzene or thinner
• Acid
• Alkaline or abrasive detergents
• Chemical Cleaning cloths
2 | Enclosure Assembly and Cleaning
Advertisement
Table of Contents
