Table of Contents
Advertisement
P
ROGRAMMING
To hold a call
(page 2-22)
To create a
multiparty
conference
(page 2-32)
5-14
A
K
UTODIAL
EYS
Using soft park...
1
While connected to another party, press <SFPK>.
2
Press the <SFPK> a second time to retrieve the call.
Using a hold loop...
1
While connected to another party, press a hold loop.
2
Press the same hold loop a second time to retrieve the
call.
Using the <HOLD> key...
1
Press the <HOLD> key while on an active call. A
CAP winks representing the held call.
2
Press the winking CAP to retrieve the call.
Follow these steps to create a multiparty conference:
1
While connected to one party, press <CONF>.
2
Dial a second party.
3
After the called party answers, press <CONF> to
create a three-party conference.
4
To add an additional party, press <CONF>; then dial
the desired number. Press <CONF> after the called
party answers. A conference can consist of up to six
parties.
5
To exit the conference, press <JOIN>.
U
FAC
SING
S
HCXTD860, Rev. A01, September 2001
S
S
940A U
ELEC
ET
G
SER
UIDE
Advertisement
Table of Contents
