Creating A Three-Party Conference - Hitachi SelecSet 900 User Manual

S S 940A U
ELEC ET

Creating a Three-Party Conference

Procedure
HCXTD860, Rev. A01, September 2001
G
SER UIDE
To create a standard three-party conference:
1 While connected to one party, dial a second party. The
first party is automatically placed on hold, and an idle
CAP is automatically selected.
2 Press <JOIN>, and when the called party answers,
announce the call.
3 Press <CONF> to connect all parties or press
<CONF> as soon as the called party picks up to
connect all parties immediately (without announcing
the call).
Note:
4 To disconnect the last person added to the conference,
press <CNCL>.
5 To exit the conference without disconnecting the
other two parties, press <JOIN> The conference is
still connected but no longer in your control.
6 To place the conference on hold, press <HOLD>.
A conference can only be held by pressing the
<HOLD> key. Soft park and hold loops cannot be
used to hold a conference.
7 To retrieve the held conference, press <START>, then
the winking CAP representing the held conference.
C
REATING A
Wait for the party to pick up before pressing
<CONF>. If you press <CONF> before the
called party picks up, your action is ignored.
T -P C
HREE ARTY ONFERENCE
2-29