Hitachi SelecSet 900 User Manual page 146

Attendant operations
Hide thumbs Also See for SelecSet 900:
Table of Contents

Advertisement

S
S
940A U
ELEC
ET
1, 4
CB/NA
Cover busy/no answer —dial the CB/NA access code plus the
number of the station to which your calls will be directed. Calls
2, 4
COVR
made to your station while you are on a call or when you do not
(Call
answer ring at the specified station. Dial the CB/NA cancellation
coverage)
code to cancel this feature.
Cover all calls —Press <COVR>. All calls go directly to the
station specified for CB/NA. No calls ring at your phone. Press
<COVR> again to cancel cover all calls.
A separate feature access code must be used to invoke CB/NA for
internal calls and incoming calls. The same or different station
numbers may be specified as the coverage point for internal and
incoming calls
If you activate CAC or FAC (call forwarding) (internal or external), your
<COVR> lamp lights. Pressing the <COVR> key cancels both features. To
cancel only one of the features, dial the appropriate cancellation code.
DISC
Disconnects and provides dial tone.
Disconnect
E911
911 alarm key. The lamp for this key blinks when a 9-1-1 call is
made. Pressing the key displays the number of the station that
made the call. This information is then deleted from the 911 call
queue. The lamp on all attendants continues to blink until all 911
calls in the queue are deleted.
1, 4
FAC
Calls can be forwarded to another station. A separate forward all
calls (FAC) access code is used to forward calls to an internal or
(Call
outside phone. When this feature is active, all calls to your phone
forwarding)
are forwarded. Dial the FAC feature access code to activate. Dial
cancellation code, or press <COVR> to cancel.
Use call forwarding internal or external (outside), but not both at
the same time. Forward all calls sends all calls to one destination.
2, 3
DET
This key lights when the link between the HCX and the answering
device is down.
(Answer
detection
alarm)
HCXTD860, Rev. A01, September 2001
P
G
ROGRAMMABLE
SER
UIDE
Table 5-3 SelecSet 940A Features(continued)
F
EATURES FOR
S
S
K
ELEC
ET
EYS
5-5

Advertisement

Table of Contents
loading

Table of Contents