Table of Contents
Advertisement
R
L
ECEIVING A
INE
Code Calls
About code
calls
Placing a code
call
Receiving a
code call
3-20
L
A
OCKOUT
LARM
A code call indicates an emergency. When you make a
code call, it causes special ringing (four quick rings) at a
station dedicated to receive code calls. The person who
receives the call uses the paging system to announce the
emergency or give appropriate instructions (there may be
several code calling stations in your facility). Keep a list of
code calling access codes for each dedicated station, along
with their location, near your console.
Follow these steps to place a code call:
1
Press <START>.
2
Dial the desired code calling access code. The code
call is sent to the dedicated station.
Note:
Code calling access codes can be programmed
as autodial numbers. See
Autodial Keys Using FACs"
instructions.
If you are designated as a code calling station, code calls
ring with a special ringing pattern (four quick rings) at the
<CODE> key and the <ANS> key. If you receive a code
call, use zone paging to announce the emergency or give
instructions. Keep a list of zone numbers nearby.
S
S
ELEC
"Programming
HCXTD860, Rev. A01, September 2001
940A U
G
ET
SER
UIDE
on page 5-11 for
Advertisement
Table of Contents
