Cisco Wireless Ip Phone 882X Series Accessory Guide - Cisco 8821 Accessory Manual

Cisco Accessories
a) Hold the bracket on the wall, as shown in the diagram.
b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.
c) Install the anchors, using the drill and drill bit.
d) Screw the bracket to the wall.
Step 3
Locate the post holders in the multicharger.
Step 4 Hold the multicharger so that the post holders are in front of the posts on the bracket, press the multicharger
towards the wall, and then push the multicharger down so that the posts seat into the holder.
Here is a close-up of the post holder.
Install the Multicharger Wall Mount Kit

Cisco Wireless IP Phone 882x Series Accessory Guide

13