Set Up The Multicharger; Install The Multicharger Wall Mount Kit - Cisco 8821 Accessory Manual

Set Up the Multicharger

Do not use chargers in a Potentially Explosive Atmosphere.
Caution
Do not charge the phone if it is wet.
Set Up the Multicharger
The power jack is on the right side of the multicharger.
Procedure
Step 1 Plug the jack end of the power cord into the multicharger.
Step 2
Plug the other end of the power cord into the power adapter.
Step 3 Plug the power adapter into the electrical outlet.
Step 4 Place the multicharger on a stable work surface.

Install the Multicharger Wall Mount Kit

The wall mount kit comes with the following components:
• bracket
• package with 5 screws and 5 self-tapping wall anchors
Before You Begin
You need the following tools:
• Drill and a 0.25 inch drill bit
• Pencil
• Level
• Philips #1 and #2 screwdrivers
You need the power cable and power adapter.
Procedure
Step 1 Determine the location for the bracket. The bottom right corner of the bracket must be less than 50 inches
(127 cm) from an electrical outlet.
Step 2 Mount the wall bracket.
Cisco Wireless IP Phone 882x Series Accessory Guide
12
Cisco Accessories