Connecting A Vcr - RCA 40 Owner's Manual

Connecting a VCR

To connect your VCP to a VCR so you can copy video tapes, connect the VCP's
jacks to the VCR's audio and video input jacks using a video-quality shielded cable
VIDEO OUT
(not supplied). Then see "Copying a Video Tape" on Page 18 to find out how to copy a tape.
AUDIO and VIDEO OUT Jacks
VCP
VIDEO
OUT
DC IN 12V
AUDIO
OUT
Notes:
• You must use a video-quality cable for this type of connection. Do not use a standard
audio cable. Your local RadioShack store sells the correct type of cable.
• You can connect the VCR's audio/video output jacks to your TV's input jacks using
another video-quality shielded cable, or to the antenna output jack using 75-ohm cable.
This lets you watch a tape while you copy it (see "Copying a Video Tape" on Page 18).
You can also connect your TV to the VCP's
TV" on Page 7.
ANT.IN
3
4
CHANNEL
RF.OUT
Audio and Video
Input Jacks
AUDIO VIDEO
OUT
VCR
IN
terminal. See "Connecting a Standard
RF.OUT
and
AUDIO
OUT TO TV
IN FROM ANT
CH.4
VHF
CH.3
UHF
9